Why does my westinghouse tv turn off

When that part of the spectrum has a lot of 'noise' in it, such as from a dying fluorescent light, your TV may have an issue properly sensing the infra-red signal being sent from your remote control. Try turning off any lights in the area, then try your remote again.

If it starts working properly, the lamp you turned off is the cause of the interference and should be replaced. Try turning off any devices you may have connected to your television, such as your cable or satellite box, any streaming media players, or Blu-Ray players. Because your TV has not responded to the previous troubleshooting steps, it means your Smart TV's basic control system has crashed, and it will need to be physically power cycled. Get Tech Support See How it Works video.

For Business. Step-by-Step Guides. Contact Us. There is one step you can take here, both as a possible fix, as well as a diagnostic evaluation 1 Unplug the power cord from the TV. When plugging back in, go directly to the wall outlet, bypassing any power strips or surge protectors.

Let me know-. Try unplugging the power cord from the back of the tv not the wall for 10 minutes then plug it back in and press the power button the tv a few times. My Westinghouse 55 always does this and is annoying. D IY F orums. You can easily reset your Westinghouse television without a remote by resetting it via the reset button at the back of the TV!

You just need a thin pointy-edged material like a pen or a SIM card pin. Also, there is another way to reset the remote which we will discuss in this article. Ensure the TV is plugged into a live electrical outlet that is not controlled by a wall-mounted light switch.

Temporarily plug a lamp into that same outlet to ensure the power is good. Replace the batteries in your remote control. Try to power on your TV with the power button on the TV. Could be your power board or your LCD backlight. Remove the back off of your TV unplug your set of course and do not touch anything and take a look at the power board. Check for leaking, domed looking capacitors as well as anything else that might look odd.

Without much delay, let us start the article. Factory resetting your television is important in too few different situations. However, the most common would be:. The next reason might be because there are several programs and applications that are crashing or closing. This problem is usually solved by a simple restart or power cycle of the device. One way to approach this is to reset it.

There are instances where the system is experiencing an overload of information, and the only way around it is to reset it back to its factory settings. These are just some of the repeated reasons reported by the vast majority of Westinghouse television users.

Wiping all of the data and the information you have on your Westinghouse television is an easy process.